Features of anti-static rubber board:
(2) conducting static electricity
Explanation of antistatic rubber plate
Antistatic rubber board in the mat semiconductor devices, electronic computers and other production workshops and advanced laboratory, the role of static electricity to reduce or eliminate. After laying the antistatic rubber board, the working face can discharge the body static electricity, so that the human body and the table contact tweezers, tools, appliances, instruments and so on to achieve the basic uniform potential, so that the electrostatic sensitive device is not friction electricity and other electrostatic discharge phenomenon produced by the interference of wide step surface, so as to achieve the electrostatic protection effect. Contact with acid and alkaline solvents is strictly prohibited on the surface of anti-static rubber board products, which may cause discoloration, fading and resistance value decline. If need to clean, may wipe cloth with neutral solution. The glue that USES should be mixed stage mat product bottom to want to be mixed workbench material photograph again, already agglutinate is firm, won't appear product to stick again after occurrence shrinkage phenomenon.
Precautions for the use of anti-static rubber board:
First of all, the surface of anti-static rubber products are prohibited from contact with acid and alkaline solvents such as benzene, alcohol, etc., which may lead to discoloration of the product surface, fading and resistance value of the recession. If need to clean, usable dishcloth is stained with neuter solution such as water to wipe. The glue that USES should be mixed with product bottom to want to be mixed with workbench material photograph solution already firm, won't appear product to stick again after occurrence shrinkage phenomenon. It is recommended to paste the test before batch production. The product shrinkage is: the product contains more glue than the general high, the durability increases, and the tensile strength increases accordingly. It is recommended that the product specification be relaxed when cutting and stored for 24 hours at the same time, so that the product has a fatigue recovery process, and then the product is glued to produce. For good performance, must pay attention to the above.